Wiring & Commissioning Instructions Elsema Receiver/Remote Control 4-channels (Gen 3)

This article covers how to setup the Elsema Receiver & remotes and pair them with the receiver installed in the Sigma Gate.

Please note that this is our Generation 3 Receiver/Remote Control set with 4-channels.

1. Wire the Receiver to Sigma Gate Control Board

*Please note that the terminals are misaligned to the labels on the blue face, it is important to count the terminals as displayed above.

Connecting Power

1. Open the Sigma gate panel.
2. Connect Supply + to 12v on the Sigma control board.
3. Connect Supply - to Ground on the Sigma control board.

Relay 1 (Auto-Close)

1. Connect Ch1 NO to Front Open on the Sigma control board.
2. Connect Ch1 C to Ground on the Sigma control board.

Relay 4 (Latched/Cleaning Mode)

*Please note that on a 3 gate store this will only be required on one receiver

1. Connect Ch4 NO to Cleaning on the Sigma control board.
2. Connect Ch4 C to Ground on the Sigma control board.
   
   
   

2. Mount the Receiver

1. Mount the receiver using the mounting screw holes circled in red.
   

3. Set the DIP Switches & Pair Remotes

1. Change Mode Selection on the 6 DIP switches (outlined in red below) to OFF OFF OFF ON OFF OFF or Down Down Down Up Down Down.
   
   
   
2. On all receivers set switches 1-10 (outlined in green below) to match the store number using the examples in the table below. As an example if the store has a number 8 in the store number set DIP switch 8 to the ON/Up position and ignore any zeros in the store number. If the store has the same number more than once like 8888 only switch 8 must be set to ON/Up and rest will be down/off.
   
   
   
   
3. For Gate 1 using button 1 on the remote for auto-close and button 4 on the remote for Cleaning Mode set DIP switches 11 to OFF/DOWN and 12 to OFF/down as shown below.
   
   
   
   
4. For Gate 2 using button 2 on the remote for auto-close set DIP switches 11 to ON/Up and 12 to OFF/DOWN on the receiver as shown below.
   
   
   
   
5. For the gate that will be using cleaning Mode button 3 on the remote for auto-close and button 4 on the remote for Cleaning Mode set DIP switches 11 to OFF/DOWN and 12 to ON/Up on the receiver as shown below.
   
   
   
   
6. Set all remote 1-10 DIP switches to match the receiver/store code and set DIP switch 11 to OFF/Down and 12 to OFF/Down.
   
   
   
   
7. Set DIP switches in the remote 1-10 exactly the same as the receiver and set switches 11 and 12 to OFF.
   
   
8. Lastly insert the battery in the remote and test.