The customer-facing safety radar is used to extend the area covered by the PEC sensors between the gates. This radar will keep the gates from closing when the customer is within a few steps of the gate.
NOTE: The radar WILL NOT open the gates once the gate has been closed. The opening of the gates remains the responsibility of the Sesame Sigma system.
1. Remove the screw and washer from the bracket and discard the bracket supplied. Use the bracket screw to mount the customer-facing radar to the bracket in the corner of the SigmaGate.
2. Connect the customer-facing radar with the following connections:
- +12v = Green wire
- GND = Brown and Yellow wires
- OPEN NEXT/ SCO CLOSE = White wire
3. Adjust the potentiometer on the side of the radar as shown in the image below left to set the detection range. The radar's red LED will illuminate when a customer is detected as shown in the image below right.